What is the reason for transaction stalled error while running flash_firmware.sh

I am getting the following error while running `ros2 run micro_ros_setup flash_firmware.sh`
```
Flashing firmware for zephyr platform olimex-stm32-e407
Bus 003 Device 018: ID 15ba:002a Olimex OpenOCD JTAG ARM-USB-TINY-H
Open On-Chip Debugger 0.11.0
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : auto-selecting first available session transport "jtag". To override use 'transport select '.
Info : clock speed 2000 kHz
Info : JTAG tap: stm32f4x.cpu tap/device found: 0x4ba00477 (mfg: 0x23b (ARM Ltd), part: 0xba00, ver: 0x4)
Info : JTAG tap: [stm32f4x.bs](http://stm32f4x.bs/) tap/device found: 0x06413041 (mfg: 0x020 (STMicroelectronics), part: 0x6413, ver: 0x0)
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Info : stm32f4x.cpu: hardware has 0 breakpoints, 0 watchpoints
Info : starting gdb server for stm32f4x.cpu on 3333
Info : Listening on port 3333 for gdb connections
Info : JTAG tap: stm32f4x.cpu tap/device found: 0x4ba00477 (mfg: 0x23b (ARM Ltd), part: 0xba00, ver: 0x4)
Info : JTAG tap: [stm32f4x.bs](http://stm32f4x.bs/) tap/device found: 0x06413041 (mfg: 0x020 (STMicroelectronics), part: 0x6413, ver: 0x0)
Error: Could not find MEM-AP to control the core
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Info : DAP transaction stalled (WAIT) - slowing down
Error: Failed to enable the FPB
TARGET: stm32f4x.cpu - Not halted
[ros2run]: Process exited with failure 1
```

I have the STM32-E407 Board and flashing via ARM-USB-TINY-H. At times it works after I press reset for some time. And after sometime if I try to flash again with a new program this happens.

Bắt đầu với entry point `ros2 run micro_ros_setup flash_firmware.sh` và kiểm tra cách nó gọi OpenOCD cho Olimex STM32-E407. Tái hiện lỗi không liên tục với ARM-USB-TINY-H và so sánh các lần chạy trong đó việc nhấn reset cho phép flash. Hoàn thành khi xác định được nguyên nhân của giao dịch bị treo và ghi lại các bước flash đáng tin cậy.

Do mô hình lập chỉ mục viết ra từ nội dung của issue.