254mm lengs is to big for Prusa printers

Hello and thank very you for the great 3D data!

Unfortunately the long parts are 4mm too long. I have a Prusa MK3 that can only print 250mm. I tried to shrink the models by 1.5% so that they would fit on my print bed, but then the recesses no longer fit.

It would be sooo great if the long parts were a little shorter then hobbyists could also join in with Prusa.

I'm also looking for a slot for PI5 and Geekworm X1200 5V UPS Shield + HAT - Is that anyhow possible?

Besties, Stefan

先在專案的 3D 資料中找出較長的零件，並根據 Prusa MK3 的 250 mm 列印限制進行檢查。確認縮短這些零件後仍能維持與凹槽的貼合，並評估是否可以為 Raspberry Pi 5 和 Geekworm X1200 UPS Shield + HAT 設置插槽。較長的零件無需縮放即可裝入，且已處理所要求的硬體相容性，即表示完成。

由索引模型根據 Issue 內容生成。