254mm lengs is to big for Prusa printers

Hello and thank very you for the great 3D data!

Unfortunately the long parts are 4mm too long. I have a Prusa MK3 that can only print 250mm. I tried to shrink the models by 1.5% so that they would fit on my print bed, but then the recesses no longer fit.

It would be sooo great if the long parts were a little shorter then hobbyists could also join in with Prusa.

I'm also looking for a slot for PI5 and Geekworm X1200 5V UPS Shield + HAT - Is that anyhow possible?

Besties, Stefan

Start by locating the long parts in the project's 3D data and checking them against the Prusa MK3's 250 mm print limit. Verify that shortening them preserves the recess fit, and assess whether a slot for the Raspberry Pi 5 and Geekworm X1200 UPS Shield + HAT is possible. Done means the long parts fit without scaling and the requested hardware compatibility is addressed.

Written by the indexing model from the issue text.