`Validate Nozzle N1's Offset` makes nozzle crash into the datum
Nobody has claimed this yet.
- Dominant language
- Python
- Stars
- 19
- Forks
- 36
- PR merge metrics
- No merged PRs in 30d
Description
Hello,
I was re-installing openpnp and while following the calibration docs, the Validate Nozzle N1's Offset step 2 with a Z at zero makes the nozzle crash into the datum board.
I started over the nozzle offset calibration making sure that I have checked 'include Z' but got the same result ... If I manually jog the nozzle to barely touch the datum board and I got Z = 15.000.
Did I miss something ?
Thanks
Contributor guide
No contributing guide indexed for this repository
First steps
- Read the whole issue, then the project's contributing guide.
- Comment on the issue to say you are picking it up — it saves two people doing the same work.
- Fork the repository and make your change on a branch.
- Open a pull request that references the issue number.
Research direction
Start by reading the calibration documentation section for “Validate Nozzle N1's Offset,” especially step 2 and its Z=0 instruction. Compare that guidance with the reported Z=15.000 position where the nozzle barely touches the datum board. Done means determining whether the step needs clarification or correction and documenting the expected behavior.
Written by the indexing model from the issue text.
Assessment
- Domain
- documentation
- Issue type
- Documentation
- Difficulty
- 3/5
- Estimated time
- 1-2 days
- Activity status
- Stale
- Clarity
- Needs clarification
- Newbie friendliness
- 35/100