MediaTek MT7603E (MT7603EN)

I collected the firmware from master, installed it on my router zbt-wg108
The 2.4 ghz signal is very bad

iw phy

Wiphy phy0
        max # scan SSIDs: 4
        max scan IEs length: 2257 bytes
        max # sched scan SSIDs: 0
        max # match sets: 0
        max # scan plans: 1
        max scan plan interval: -1
        max scan plan iterations: 0
        Retry short limit: 7
        Retry long limit: 4
        Coverage class: 0 (up to 0m)
        Device supports T-DLS.
        Available Antennas: TX 0x3 RX 0x3
        Configured Antennas: TX 0x3 RX 0x3
        Supported interface modes:
                 * IBSS
                 * managed
                 * AP
                 * AP/VLAN
                 * monitor
                 * P2P-client
                 * P2P-GO
        Band 1:
                Capabilities: 0x1fe
                        HT20/HT40
                        SM Power Save disabled
                        RX Greenfield
                        RX HT20 SGI
                        RX HT40 SGI
                        TX STBC
                        RX STBC 1-stream
                        Max AMSDU length: 3839 bytes
                        No DSSS/CCK HT40
                Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
                Minimum RX AMPDU time spacing: No restriction (0x00)
                HT TX/RX MCS rate indexes supported: 0-15
                Frequencies:
                        * 2412 MHz [1] (20.0 dBm)
                        * 2417 MHz [2] (20.0 dBm)
                        * 2422 MHz [3] (20.0 dBm)
                        * 2427 MHz [4] (20.0 dBm)
                        * 2432 MHz [5] (20.0 dBm)
                        * 2437 MHz [6] (20.0 dBm)
                        * 2442 MHz [7] (20.0 dBm)
                        * 2447 MHz [8] (20.0 dBm)
                        * 2452 MHz [9] (20.0 dBm)
                        * 2457 MHz [10] (20.0 dBm)
                        * 2462 MHz [11] (20.0 dBm)
                        * 2467 MHz [12] (20.0 dBm)
                        * 2472 MHz [13] (20.0 dBm)
                        * 2484 MHz [14] (disabled)
        valid interface combinations:
                 * #{ IBSS } <= 1, #{ managed, AP, P2P-client, P2P-GO } <= 4,
                   total <= 4, #channels <= 1, STA/AP BI must match
        HT Capability overrides:
                 * MCS: ff ff ff ff ff ff ff ff ff ff
                 * maximum A-MSDU length
                 * supported channel width
                 * short GI for 40 MHz
                 * max A-MPDU length exponent
                 * min MPDU start spacing
        Supported extended features:
                * [ RRM ]: RRM
                * [ CQM_RSSI_LIST ]: multiple CQM_RSSI_THOLD records
                * [ CONTROL_PORT_OVER_NL80211 ]: control port over nl80211
                * [ TXQS ]: FQ-CoDel-enabled intermediate TXQs
                * [ AIRTIME_FAIRNESS ]: airtime fairness scheduling

cat /sys/kernel/debug/ieee80211/phy0/mt76/rate_txpower
root@Route:~# cat /sys/kernel/debug/ieee80211/phy0/mt76/rate_txpower CCK: 0 0 0 0 OFDM: 0 0 0 0 0 0 0 0 STBC: 0 0 0 0 0 0 0 0 0 0 HT: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 VHT: 0 0 0 0 0 0 0 0 0 0 root@Route:~#

EEPROM
eeprom.zip

No source file or test is identified. Start with the reported iw phy output, the mt76 rate_txpower debug path, and the attached EEPROM data; compare these with the MT7603E firmware collected from master. Done means identifying a reproducible driver or firmware cause for the weak 2.4 GHz signal and documenting the required change or missing evidence.