NodeMCU 1.0 (ESP-12E Module) OTA problem

### Basic Infos

#### Hardware
Hardware: NodeMCU 1.0 (ESP-12E Module)
Core Version: ??

### Description

Hi!
Can't establish OTA update using BasicOTA example code. Upload sketch using USB connection, pushing RST button on module, unplug module from laptop, connect it to other power source.
After power-on ESP get IP and Arduino IDE seen it on IP ports, but when i try to upload this sketch again, but now in OTA-mode, i get Error[4]. All FireWalls are disabled, ping on IP in cmd get no issues.
Thanks in advance for any help with this one!

### Settings in IDE

Module: NodeMCU 1.0 (ESP-12E Module)
Flash Size: 4MB/1MB
CPU Frequency: 80Mhz
Flash Mode:
Flash Frequency:
Upload Using: OTA
Reset Method:

### Sketch

#include
#include
#include
#include

const char* ssid = "XXXX";
const char* password = "XXXX";

void setup() {
Serial.begin(115200);
Serial.println("Booting");
WiFi.mode(WIFI_STA);
WiFi.begin(ssid, password);
while (WiFi.waitForConnectResult() != WL_CONNECTED) {
Serial.println("Connection Failed! Rebooting...");
delay(5000);
ESP.restart();
}

// Port defaults to 8266
// ArduinoOTA.setPort(8266);

// Hostname defaults to esp8266-[ChipID]
// ArduinoOTA.setHostname("myesp8266");

// No authentication by default
// ArduinoOTA.setPassword("admin");

// Password can be set with it's md5 value as well
// MD5(admin) = 21232f297a57a5a743894a0e4a801fc3
// ArduinoOTA.setPasswordHash("21232f297a57a5a743894a0e4a801fc3");

ArduinoOTA.onStart([]() {
String type;
if (ArduinoOTA.getCommand() == U_FLASH)
type = "sketch";
else // U_SPIFFS
type = "filesystem";

// NOTE: if updating SPIFFS this would be the place to unmount SPIFFS using SPIFFS.end()
Serial.println("Start updating " + type);
});
ArduinoOTA.onEnd([]() {
Serial.println("\nEnd");
});
ArduinoOTA.onProgress([](unsigned int progress, unsigned int total) {
Serial.printf("Progress: %u%%\r", (progress / (total / 100)));
});
ArduinoOTA.onError([](ota_error_t error) {
Serial.printf("Error[%u]: ", error);
if (error == OTA_AUTH_ERROR) Serial.println("Auth Failed");
else if (error == OTA_BEGIN_ERROR) Serial.println("Begin Failed");
else if (error == OTA_CONNECT_ERROR) Serial.println("Connect Failed");
else if (error == OTA_RECEIVE_ERROR) Serial.println("Receive Failed");
else if (error == OTA_END_ERROR) Serial.println("End Failed");
});
ArduinoOTA.begin();
Serial.println("Ready");
Serial.print("IP address: ");
Serial.println(WiFi.localIP());
}

void loop() {
ArduinoOTA.handle();
}

### Debug Messages

Ready
IP address: 192.168.0.101
Start updating sketch
Progress: 0%
Error[4]: End Failed