bigtreetech / bigtreetech/SKRat
Can Bus terminal resistor jumper - J49
Open
- Dominant language
- C++
- Stars
- 20
- Forks
- 1
- PR merge metrics
- No merged PRs in 30d
Description
Is it necessary to set jumper on J49 in order to use CanBus?
These are the two pins between the CanBus connector and Four-Wire FAN0 connector.
In the manual i can't find any info about the terminal resistor for CanBus.
Contributor guide
No contributing guide indexed for this repository
Research direction
Start by checking the manual and the board details around jumper J49, the CANBus connector, and the Four-Wire FAN0 connector. Confirm whether J49 is the CANBus terminal resistor and document when it should be set; the manual should clearly answer the question.
Written by the indexing model from the issue text.
Assessment
- Domain
- documentation, embedded-iot
- Issue type
- Documentation
- Difficulty
- 2/5
- Estimated time
- 1-3 hours
- Activity status
- Stale
- Clarity
- Needs clarification
- Newbie friendliness
- 25/100