bigtreetech / bigtreetech/Panda_Breath
Heater stops randomly / log files
Nobody has claimed this yet.
- Dominant language
- No language data
- Stars
- 61
- Forks
- 5
- PR merge metrics
- No merged PRs in 30d
Description
Tried to use Filament drying mode (10 hours, 50 degrees) and it shut down operations after some time.
Tried the same by setting chamber temperature to 50 and again, it just shut down after some time. When I checked the web app, work mode was switched off.
Are there any log files to make sense of that behaviour?
Version 1.03 (due to requirement of SM U1 extended firmware)
If this doesn't get fixed, the whole device is a garbage and a waste of money.
Contributor guide
No contributing guide indexed for this repository
First steps
- Read the whole issue, then the project's contributing guide.
- Comment on the issue to say you are picking it up — it saves two people doing the same work.
- Fork the repository and make your change on a branch.
- Open a pull request that references the issue number.
Research direction
No log file, test, or code entry point is named in the issue. Start by checking whether the web app or device exposes logs for the heater and review the reported firmware version; done means identifying why the work mode switches off or documenting the relevant failure evidence.
Written by the indexing model from the issue text.
Assessment
- Domain
- embedded-iot
- Issue type
- Bug
- Difficulty
- 4/5
- Estimated time
- 3-5 days
- Activity status
- Quiet
- Clarity
- Needs clarification
- Newbie friendliness
- 35/100