RGB pin PE9

So i have hooked up two different rgb lights to pin PE9 and tested the pins as well. There is no power going to this header and had to make a custom cable to run both lights on PE10.

Has anyone else had this problem? This board has been the biggest headache so far.

Any suggestions would be greatly appreciated.

Start by reproducing the reported PE9 and PE10 behavior with the two RGB lights and the custom cable, then verify whether PE9 supplies power at the header. Done means establishing whether this is a board fault, wiring issue, or expected pin behavior and documenting the evidence and recommended resolution.

Written by the indexing model from the issue text.