Microprobe not working correctly with btt pico

> just to give my two cents here, had the same issue on an skr pico, it wouldn't stow on it's own, sometimes it would stow after a while, deploying was ok, but stopped working when i sent the stow command, this by using the stock wires, both long and short, i also got a new microprobe just to check if the old one was defective, same results, i managed to get it working by wiring the servo part to the raspberry pi pins directly, and updating the pin reference in order to reference a gpio of the pi. works reliably now.

_Originally posted by @MrFanfo in [#16](https://github.com/bigtreetech/MicroProbe/issues/16#issuecomment-2404280472)_

I have the issue where it will go down but it take forever to go back up. How do I get it to reference a gpio of the pi and stuff? I am using a btt pi v1.2