bigtreetech / bigtreetech/MicroProbe
New install on SKR3 won't home Z
Open
- Dominant language
- No language data
- Stars
- 122
- Forks
- 20
- PR merge metrics
- No merged PRs in 30d
Description
I just finished the install on my printer with an SKR3 board. I followed the directions to a T and have triple checked the firmware. Z axis only goes up and when it goes down, it stops after about 15 mm then says probing failed. Everything is wired properly.
Contributor guide
No contributing guide indexed for this repository
Assessment
This issue has not been assessed yet.