SB2240 Thermocouple issue

Can anyone help me figure out why my EBB2240 is displaying -93 degrees for my Hotend temp? Im using a Rapido hotend and i think its Pt1000. I have tried using these settings
sensor_type:MAX31865
sensor_pin: EBBCan: PA4
spi_bus: spi1
rtd_nominal_r: 1000
rtd_reference_r: 430
rtd_num_of_wires: 2
If i try the setting below I get thermal couple issue.
sensor_type: ATC Semitec 104NT-4-R025H42G
sensor_pin: EBBCan: PA3
control: pid
i get -93 degrees.
im connected 2 wires to the four pin connector and the jumpers are PT1000 1-on 2-on 3-off 4-on
please help. i even replaced this board and it still dont work.
tkostansek — Today at 10:00 AM
MCU 'EBBCan' shutdown: Thermocouple reader fault
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown

Start with the EBB2240 sensor configuration in the issue, checking the MAX31865 and ATC Semitec alternatives against the stated two-wire connection and jumper positions. Reproduce the -93° reading and thermocouple reader fault; the issue is done when the selected configuration reports a plausible hotend temperature without shutting down.

Written by the indexing model from the issue text.