SB2209 USB need modded STLs

As is the SB 2209 board is not even remotely compatible with the Galileo 2 extruder (and probably any related extruder) as the back USB port cuts into the main body. I found a third party modded main body that partly solves the issue, but the board end up installed angles and under some stress as it catches on the top part and end up installed at an angle (potentially misaligning the connectors for the sub board). Likely a new main body and door is needed, and with the higher XT30 connector a new umbilical solution.

Start by reviewing the attached image and the compatibility issue between the SB2209 USB port, Galileo 2 extruder body, and XT30 connector. Determine the required main body, door, and umbilical changes. Done means the board fits without stress or connector misalignment and the USB and XT30 clear the surrounding parts.

Written by the indexing model from the issue text.