M4P + CB2 setup.

I am having some issues with my M4P + CB2 setup. Firstly, I accidentally broke off the Wi-Fi antenna receptacle after mounting the M4p board into its freshly printed case. Off course I plugged the antenna to the board prematurely and needed to remove it to reroute it through a printed hole for the antenna. (Dunce!) When trying to lift the antenna off its receptacle , the receptacle came clean off . So, no more high speed WIFI. So, I plugged in an ethernet cable that shows up on my router. That I can SSH into successfully.

Q1: Will not SSH-ing into the machine via Wi-Fi influence the flashing process?
Q2: Are there any other jumpers that need to be in place before I can attempt flashing the CB2 +Klipper operating system?
Q3: What should the dipswitches 1 to 4 be set to when booting from SD card and wanting to flash to eMMC? Is it: 1=on, 2=off, 3=on & 4=on ?

When trying the Flash by USB-C cable and the RKDevTool:
Q4: Is it: 1=off, 2=on, 3=on & 4=off ?
Q5: What exactly is the sequence of steps to take to get my Device manager to recognise the Loader device? I don’t seem to get that right.

Any help would be greatly appreciated at this point.

Many thanks in advance
Vaughan

Start with the CB2 setup and flashing instructions for the dip-switch settings, SD-to-eMMC process, and prerequisites. Then review the RKDevTool USB-C Loader recognition sequence and whether Ethernet SSH changes flashing. Done means Q1–Q5 each has an authoritative, reproducible answer.

Written by the indexing model from the issue text.