manta mp8 klipper firmware update

When running make menuconfig from klipper, what options do I have to select to update but use the default card?
https://imgur.com/gcr1KSL
This part is different from the manual

and now the command ls /dev/serial/by-id/*
reports that there is no serial port

biqu@BTT-CB1:~$ ls /dev/serial/by-id/*
ls: cannot access '/dev/serial/by-id/*': No such file or directory
biqu@BTT-CB1:~$
biqu@BTT-CB1:~$ sudo ls /dev/serial/by-id/*
ls: cannot access '/dev/serial/by-id/*': No such file or directory
biqu@BTT-CB1:~$

Start with the reported `make menuconfig` step and compare the available options with the referenced manual, then run `ls /dev/serial/by-id/*` after the firmware update. Done means the correct configuration for the default card is identified and the expected serial device is available, or the missing-device cause is documented.

Written by the indexing model from the issue text.