Bare Metal- Segregate control plane and data plane traffic on seperate NIC/VLANs

Hi,

My worker nodes are configured with 2x100Gig and 2x25Gig network interface cards. My control plane node is configured with 2x25Gig network interface card. Is there a possibility or is it a valid configuration to separate the control plane traffic to go over the 2x25Gig leaving 100Gig interfaces for data plane. Obviously, the consideration would be to place 2x100Gig and 2x25Gig on worker nodes in separate vlans. Is this is a valid configuration. Will Tinkerbell support it in hardware.csv to configure multiple interfaces with different subnets.

Start with the Tinkerbell hardware.csv configuration mentioned in the issue and determine whether it can represent multiple NICs with separate subnets or VLANs. Done means the validity of segregating control-plane and data-plane traffic is established, along with the supported hardware.csv representation or a clearly identified limitation.

Written by the indexing model from the issue text.