How to run Owfuzz with a wireless network card

The intro says "Owfuzz can also use a wireless network card that supports monitor mode and frame injection", so I just have a try:

1. Setup Owfuzz on my Kali virtual system, the compilation goes well.
2. Plugin a wireless network card, change its mode to monitor by `iwconfig`.
3. To fuzz client, I have to use AP mode, so I start a hostpot by `hostapd`, thus I can make my client in the same network with my Kali, and I get the ip of my client and take it as the parameter of `I`.
4. Then I start Owfuzz by `sudo ./owfuzz -i wlan0 -m ap -c [channel] -t [sta-mac] -b [ap-mac] -s [ap-mac] -T 2 -A WPA2_PSK_TKIP_AES -I [sta-ip]`

Then the problem comes: the function `init` in `fuzz_control.c` will restart my wlan0 interface, which will shutdown my hostpot, and the fuzz result seems abnormal. I guess the fuzzer cannot communicate with my client.

Then I trys to comment these codes `kismet_interface_down`, `kismet_set_mode`, `kismet_interface_up`. However, the fuzzer will go error which says the channel is not matched, which means `kismet_set_channel` is not working. The reason may be the comment. However I have no idea dealing with it. Any ideas?

It'll be more helpful if there is a manual of how to use owfuzz on a wireless network card.

Best