Issue with Ogg Recording Example on VS1053 Breakout Board

### Problem Description
I'm currently facing challenges with the Ogg recording example on the breakout board utilizing the VS1053 chip. My recorded files consistently exhibit a recurring issue. Specifically, there are missing words in the recordings.

### Steps Taken
Set recording pin to GND.
Speak into the microphone.
Remove the record pin from GND.
Wait for a brief period.
Disconnect the Arduino Nano.
Insert the SD card into the computer to listen to the recording.
Attempted Solutions
I've experimented with various approaches, including:

### Trying different SD card libraries.
Adjusting buffer sizes to potentially address the missing words issue.
However, none of these attempts have resolved the problem.

### Request for Assistance
I'm reaching out to the community for guidance. Has anyone successfully used this breakout board for recording? If so, were there specific modifications or adjustments made to ensure reliable recording without missing words? Any insights or suggestions would be greatly appreciated.

Thank you for your assistance!

Reproduce the Ogg recording example on the VS1053 breakout board with an Arduino Nano, the recording pin, microphone, and SD card as described. Compare recordings while investigating the reported buffer-size and SD-card-library changes. Done means recordings no longer consistently omit spoken words, with the tested setup and any reproducible findings documented.

Written by the indexing model from the issue text.