Firmware, device went to AP mode and did not reconnect to the wifi Network
Nobody has claimed this yet.
- Dominant language
- C++
- Stars
- 8
- Forks
- 6
- PR merge metrics
- No merged PRs in 30d
Description
Describe the bug
A clear and concise description of what the bug is.
Short Summary of the expected behavior: wifi connected
Short Summary of the buggy behavior: Wifi stayed disconnected (device went to AP mode) when the Wifi Network went out for 2 minutes
To Reproduce
Steps to reproduce the behavior: turn of your wifi Network for approximately 2 minutes
Check the device wifi status and the IP address.
Expected behavior
A clear and concise description of what you expected to happen.
Screenshots
If applicable, add screenshots to help explain your problem.
Hardware description
Model:
Serial Number:
Other:
Test Equipment
Model:
Serial Number:
Additional context
Add any other context about the problem here.
Contributor guide
No contributing guide indexed for this repository
First steps
- Read the whole issue, then the project's contributing guide.
- Comment on the issue to say you are picking it up — it saves two people doing the same work.
- Fork the repository and make your change on a branch.
- Open a pull request that references the issue number.
Research direction
No source file or test is named. Start by reproducing the failure: turn off the Wi-Fi network for about two minutes, then inspect the firmware's Wi-Fi recovery entry point and device status/IP behavior. Done means the device reconnects to the Wi-Fi network instead of remaining in AP mode after the outage.
Written by the indexing model from the issue text.
Assessment
- Tech stack
- cpp
- Domain
- embedded-iot, networking
- Issue type
- Bug
- Difficulty
- 4/5
- Estimated time
- 3-5 days
- Activity status
- Active
- Clarity
- Mostly clear
- Newbie friendliness
- 45/100