[BUG] Artillery Sidewinder X2 Controller Fan not working

### Did you test the latest `bugfix-2.1.x` code?

Yes, and the problem still exists.

### Bug Description

With stock firmware the controller fan starts spinning when heat bed is over 50°C or stepper motors are working
With bugfix-2.1.x there is only a clicking sound from the controller fan, never turns on
With 2.1.2.1 the controller fan starts spinning over 50°C but then stalls and just make clicking sound

I lowered #define CONTROLLERFAN_SPEED_ACTIVE from 255 to 240 and then the controller fan is working like expected

### Bug Timeline

_No response_

### Expected behavior

Heat bed over 50°C or stepper motor working the controller fan starts spinning

### Actual behavior

Controller fan does not start spinning only clicking sounds

### Steps to Reproduce

_No response_

### Version of Marlin Firmware

2.1.2.1

### Printer model

Artillery Sidewinder X2

### Electronics

_No response_

### LCD/Controller

_No response_

### Other add-ons

_No response_

### Bed Leveling

None

### Your Slicer

None

### Host Software

None

### Don't forget to include

- [X] A ZIP file containing your `Configuration.h` and `Configuration_adv.h`.

### Additional information & file uploads

[config.zip](https://github.com/MarlinFirmware/Marlin/files/13990526/config.zip)

Start by examining the attached config.zip, especially the controller-fan settings, and compare the reported behavior across bugfix-2.1.x and version 2.1.2.1. Verify the behavior on an Artillery Sidewinder X2 with the bed above 50°C or the steppers working; done means the fan starts without clicking or stalling at the reported setting.

Written by the indexing model from the issue text.